Talking about the inspection method of excavator winding machine in detail
Release Time:
Jun 30,2021
It is understood that 43%of excavator failures are caused by improper daily maintenance,which shows how important daily inspection and maintenance are to excavators.
It is understood that 43%of excavator failures are caused by improper daily maintenance,which shows how important daily inspection and maintenance are to excavators.
The master has summarized a set of inspection methods for excavators.As long as you walk around your favorite machine for 10 minutes a day,you can complete a simple physical examination,thereby greatly reducing the failure rate of excavators.Below we Let's take a look at this set of winding machine inspection methods.
1.Observe whether there is moisture and impurities in the oil-water separator.Because domestic diesel generally contains water and has more magazines,in order to extend the life of your fuel system,we recommend that you drain the diesel tank and the oil-water separator before working every day.
2.Park the excavator on a flat ground,take out the oil dipstick,check whether the oil level is between the H-L two scales,and check whether the oil has deteriorated.If the standard is not met,replace and refill the oil in time.Less engine oil and engine oil deterioration will lead to lack of lubrication in all parts of the body,resulting in excessive wear and damage to the body.
3.Check the excavator hoses and pipelines for leaks,kinks,breakage or damage,whether there are slight cracks in the upper and lower arms,check the wear of the bucket,and check whether the bucket teeth are loose.
Explain in detail the inspection method of the excavator around the machine
Fourth,remove the mud contaminated by the lower car body,leaning over to check whether there are obstructions around the track and the chassis.
5.Check whether the hydraulic oil level is between H-L with the hydraulic oil level gauge,and observe whether the color of the hydraulic oil is clear.If the hydraulic oil deteriorates,replace it with new hydraulic oil in time.
6.Check whether the cooling water level is between the upper limit and lower limit of the water tank.If the water level is lower than the lower limit,add cooling water to the water tank.
Seven.Before daily operation of the excavator,grease the front-end working device and various parts of the pin shaft for lubrication.Under special working environment such as water,mud or crushing,it is recommended to lubricate once every 2-3 hours.
Keywords：
More information
Jin Di
Tel:
Sales E-mail:
